|
| 11 m high pole (2nd trial). During 1st trial for installation, the pole fell out, damaging a bit the solar cells on the roof and the YAGI. |
|
|
| This will be the place of the rotator. |
|
|
| Safety first: 2 bearings. |
|
|
| YAGI before the 1st trial to set up the pole. |
|
|
| YAGI after the 1st trial to set up the pole. |
|
|
| Scaffold for easy tuning of the antenna. |
|
|
| 3 el. DUNAX YAGI (20-15-10m band) |
|
|
| FT847 |
|
|
| Shack: FT847 and 1kW PA with GS31B (by HA1YA). |
|
|
| View from the roof of the house. The antenna sees just some cm above roof top (NW direction). |
|
|
| 7 MHz dipole. River Vardar is behind the fence (reaching Aegean see in Greece under the name: Anxios). |
|
|
| Upgraded antenna: 3+2 el. YAGI by DUNAX (I suppose it was the 1st prototype). Below is the 15 el. DJ9BV OPT 2m antenna (8.3m boom). |
|
|
| HF and 2m YAGIs and 7-10MHz dipoles. |
|
|
| Antennas again. |
|
|
| 6 el. 6m DJ9BV YAGI under test (tuning for best SWR). |
|
|
| Dipoles under repair: relocation for better SWR and gain. |
|
|
| 6m YAGI is installed to its final place. I decided to replace 2m YAGI in Sep. 2005, since 6m seemed more interesting for me. |
|
|
| 6m was not licensed at that time in HA, later with 10 and 150W. My license is for 1kW: I wanted to utilize the legal power. |
|
|
| FT847 on 6m. I had about 750 QSO on 6m during 14 months. I activated 1st JT6M from Z3. |
|
|
| After loosing patiente due to a lot of nc MS QSOs, I decided to improve: 500W PA from HA1YA with GI46B. |
|
|
| 1kW HF PA (GS31B) by HA1YA. |
|
|
| My house and final set up of antennas. |
|
|
| The nice garden (800m2). |
|
|
| River Vardar. River of Skopje. |
|
|
| River Vardar, picture 2. |
|
|
